RotoZip RZ1 Instrucciones De Funcionamiento página 12

RZ 2610938267 02-07
Step 6: Move the Zip Bit right and upward
maintaining light continuous pressure toward
the box.
Step 8: The completed box, executed quickly,
neatly and in a fraction of the time taken by
other methods.
These step-by-step instructions are
generalized to acquaint you with the Spiral
Saw power tool operation. After some
practice, you may develop a motion
technique with which you are more
comfortable. However, you must always
begin the cut somewhat centrally, and MOVE
THE SPIRAL SAW POWER TOOL ONLY
COUNTERCLOCKWISE to take advantage
of the "hugging" action of the rotating Zip Bit
along the contours of the template.
ILLUSTRATED INSTRUCTIONS FOR MAKING PERFECT
CUT-OUTS WITH THE TRACING XBIT™
Do not attempt to use this
WARNING
!
tool to make cut-outs
around any fixture or opening which has
live electrical wires, or on any wall which
may have live electrical wiring behind it, as
the bit could conduct current to the tool,
creating an electrocution hazard for the
operator. Shut off breakers or remove fuses
to disconnect the circuit. Always hold the tool
by its thermoplastic housing, and always wear
eye protection when operating this device.
3/1/07 8:52 AM Page 12
Step 7: Round the right bottom corner and
begin moving the bit upward while applying light
pressure left toward the box until you meet
initial upward cut. Push Spiral Saw power tool
switch to off.
Remember to use a smooth continuous
motion.
Step 1: Make sure your workpiece is securely
mounted to the template.
Remember that a roughed out window
opening or other "closed loop" of construction
lumber can serve as your template when
cutting OSB or house sheathing.
obstructions including wiring and insulation
should be pinned away from the template.
-12-
All