Delay Mode - Sentry FIRE-SAFE safes Manual Del Usuario

https://www.supplychimp.com
®

Delay Mode

The lock automatically enters a two-minute Delay Mode after
an invalid code has been entered three consecutive times. In
this mode, the lock can not be activated and any key entry will
generate an ERROR signal.
Instructions for floor mounting
1. First tip the safe onto its back. Look on the bottom of the
safe for two indentations in opposite feet. Using the
(11.0 mm) bit, drill a hole through each indentation
perpendicular to the bottom of the safe. (Fig. J)
2. Turn the safe upright and place it where desired. Use
a screw or drill bit to mark the floor through both holes.
(Fig. K) Then move the safe aside to clear both marked
spots for drilling.
3. A. For wood with access underneath: Check to be
sure that neither mark is over a joist. Then, using the
(11.0 mm) bit, drill a hole through the floor in each marked
spot. (Fig. L)
B. For wood with no access underneath: Using the
9 1
⁄ " (7.2 mm) bit, drill a hole 2 ⁄ " (64 mm) deep in each
32 2
marked spot. (Fig. L)
C. For masonry: Using the 3⁄8" (9.50 mm) masonry bit,
drill a hole 2 1 ⁄ " (64 mm) deep in each marked spot. (Fig. L)
2
Install a masonry anchor in each hole according to the
manufacturer's instructions.
4. Replace the safe in the desired position, with the holes
in the safe aligned with those in the floor.
5. A. For wood with access underneath: Fasten the
safe with bolts, washers and nuts. Tighten with the
wrench. (Fig. M)
B. For wood with no access underneath: Pass each
lag screw through a washer, then through the safe and into
a hole. Tighten with the wrench. (Fig. N)
C. For masonry: Pass each lag screw through a washer,
then through the safe and into a masonry anchor. Tighten
with the wrench. (Fig. O)
Note: Must drill with door open.
J K
Questions?
Call Customer Service: 800-828-1438 or 716-381-4900,
8 am–5 pm E.S.T., M–F.
NOTE: If your safe does not appear to be working,
please check batteries before calling.
7 ⁄ "
16
TOOLS AND HARDWARE
NEEDED
Drill
7
⁄ " (11.0 mm) bit
16
7
⁄ "
16
9
⁄ " (7.2 mm) bit
32
3
Masonry anchors to fit ⁄ "
8
(M10 mm) lag screws
3
Masonry bit ⁄ " (9.50 mm) to fit
8
masonry anchorsr
Wrench
Hammer
3
⁄ " x 6" (M10 x 150 mm)hexagon
8
head bolts
Hexagon nuts
Spacer washers
3
⁄ " x 4" (M10 mm x 100 mm) lag screws
8
*Included with some models
Bolt-down hardware (not all models).
L M
� � � � � � � � � � � � � � � � � �
TYPE OF FLOOR
WOOD WOOD
(with access (without access
underneath) underneath)
2
2
4 2*
2*
Your bolt-down hardware kit contains the following:
(2) lag screws, (2) washers, (2) masonry anchors
N O
MASONRY
3
⁄ " (9.50 mm) bit
8
2*
2*
2*
7