Hofmann monty 1620 Manual Del Operador página 26

2
26
monty 1620 - 1625
3
4.1-3
4.1-4
4.1-5
Only for Tubeless wheel models:
F1. Press bead seater/infl ator pedal (1, Fig. 4.1-3) on
left side of the machine half way down: air will come
from infl ation hose end only (2, Fig. 4.1-3).
F2. Press bead-seater pedal (1, Fig.4.1-3) down swiftly
to get air blast from the turntable jets (3, Fig.4.1-3).
Note: Air simultaneously continues to exit the hose
(2, Fig. 4.1-3) connected to the tire.
WARNING: ONCE BEADING IS COMPLETE, IMME-
DIATELY STOP INTRODUCING AIR.
(Fig. 4.1-4)
WHEN OPERATING THE BEADING DEVICE IT IS
MANDATORY TO WEAR EAR PROTECTORS AND
SAFETY GLASSES TO PREVENT CONTAMINATION
FROM NOISE, DUST AND CHIPS BLOWN BY THE
AIR JETS.
DANGER OF TIRE EXPLOSION
Presetting of clamping jaws (if any):
N.B.: Turntable capacity can be changed before pedal
control.
The turntable jaws can be positioned in two diff erent
ways (Fig. 4.1-5).
Push the lever (C) on the left side of each jaw and shift
at the same each one (0/+4").
VERY IMPORTANT: LOOK FOR PROPER INSER-
TION OF THE PIN
CAUTION! MAKE SURE ALL FOUR CLAMPING
JAWS ARE MOUNTED IDENTICALLY (1 OR 2, FIG.
4.1-5). OTHERWISE THE RIM MAY COME LOOSE
AND INJURE THE OPERATOR!
Rim diameters are shown in inches on the turnta-
ble (A, Fig. 4.1-5). The diameter setting (mark on jaw
(B) must coincide with mark on turntable) depends on
the clamping jaw position 1 or 2.
· In jaws position 1 the diameter is preset directly
(1, Fig. 4.1-5).
· In jaws position 2 (2, Fig. 4.1-5) 4 inch must be
added to the diameter.
Operator's Manual