Loop Handle Version; Installing Nylon Line Cutting Head; Adjusting The Balance - Echo DPAS-TRIMMER Manual De Instrucciones

Before you start

Loop handle version

Installation of shield

Installing nylon line cutting head

Adjusting the balance

Adjusting the shoulder harness
 This product is designed to fit a wide variety of body sizes, but may not be adjustable for extremely tall persons. Do
not use the unit if your feet can reach the cutting attachment when the unit is attached to the harness.
 A person's size can affect the balancing adjustment. Also the balancing procedure may not work with some units on some
persons. If the shoulder harness does not fit you or cannot be adjusted well, please ask your dealer for assistance.
 The cut off knife on the debris shield has sharp edges.
Avoid contact when installing or removing the line
head.
1. Remove the plastic sleeve (A) from the output shaft.
2. Install the shield (B) on the bottom of the angle transmission
flange (C).
3. Place the shield plate (D) on the shield, align holes and in-
stall the three bolts (E).
4. Tighten firmly the three bolts.
 The shield is for use with the nylon line head only.
 Fix the output shaft securely using the locking tool in
order to prevent it from rotating when mounting the ny-
lon line head.
1. Be sure the blade retainer (A) remains on the output shaft
(B).
2. Align the locking hole in the blade retainer with a notch at the
edge of the angle transmission and insert the locking tool
(C).
3. Install the line head (D) onto the output shaft by turning it an-
ticlockwise until the head is tight against the blade retainer.
4. Remove the locking tool.
5. Remove the packing (E).
WARNING
IMPORTANT
10
WARNING
NOTE
CAUTION