Appliance Description; Operating The Appliance - Silvercrest SBP 1960 A1 Instrucciones De Uso

Appliance description

(See fold-out page for illustrations)
Hanger
Locking stud for the hanger
Locking clip for locking the telescopic rod
Telescopic shaft
Drip protection
Blower
Release button
LED display
Dial
Appliance base
Weight clamps to weigh down the clothes
Cable retainer
Nylon balloon to put the clothes on

Operating the appliance

CAUTION! PROPERTY DAMAGE!
► When setting up the appliance, ensure that it has sufficient free space on all
sides.
Assemble the appliance before use. Use the illustrations on the fold-out page for
additional help.
Push the telescopic shaft
appliance base
located above the blower
least 10 cm above the blower
NOTE
► To remove the telescopic shaft
button
Adjust the height of the telescopic shaft
the telescopic shaft
again. Pull the telescopic shaft
be attached.
Place the hanger
the front of the appliance. Push the locking stud
over it until the locking stud
│ GB │ MT
■ 56
into the opening provided at the top of the
until it clicks into place. The drip protection
. Make sure that it is installed at a height of at
.
again if necessary, press the release
and pull out the telescopic shaft
to the desired height and tighten the locking clip
far enough out so that the hanger
on the telescopic shaft
engages (Fig. 1).
.
. Open the locking clip
so that the curved arms face
in and slide the hanger
SBP 1960 A1
must be
, pull out
can