Roller Padding (Steel Wool); Roller Cloth Cover, Removing, Replacing And Washing - Miele professional HM 29-175 Instrucciones De Manejo

Cleaning and care
Removing the ironing cloth roller cover
Before removing the ironing cover (for clea-
ning or renewal) let the heater plate cool
down.
The end of the ironing cover must be visible
at the top of the roller.
Switch the machine off at the mains and raise
the pick-off attachment.
Loosen the side ties and lay the end of the
ironing cover over the feed in table or to the
back of the ironer.
Press the "Reverse run" Ö
fully remove the ironing cover.

Roller padding (steel wool)

Renewal or rewinding of the steel wool roller
padding should only be carried out by a Miele
authorised service engineer.
To avoid the danger of injury protective
gloves should be worn whilst renewing the
roller padding.
The following steel wool covering dimensions
should be maintained:
HM 29-175 max. 928 mm circumference
Remove any particles of steel wool that may
have fallen on the heater plate.
button and care-
(without cloth)
17
Replacing the ironing cloth roller cover
Do not wash the new cloth roller cover
before use.
Heat the roller up and in the pressed on positi-
on lay the new cloth on to the roller following
the direction of the arrow on the steel wool
covering. The front edge of the cloth should
be brushed out with a steel brush and fed in.
Let the roller run for approx. 5-10 mins, then
trim off any overlapping strands and comb
them out as done at the front edge of the
cloth.
HM 29-175 max. 948 mm circumference
Washing an ironing cloth
Ironing cloths which have slight discolouration
should, if possible, not be washed (yellowing
is normal). Heavily soiled cloths should be
washed in a Cottons 95 °C programme, spun
and put back on while still damp.
(with cloth)
M.-Nr. 05372840