Gas Connection; Exhaust Ducting - Miele professional HM 29-175 Instrucciones De Manejo

Gas connection

The gas connection may only be carried out
by a suitably qualified engineer (eg. Corgi in
the UK) in accordance with local and national
safety regulations.
The enclosed installation diagram and the
installation instructions for gas must be follo-
wed to ensure correct gas connection.
Check the adhesive label at the rear of the
machine for the gas type to which the
machine has been set at the factory.
When converting to liquid gas or another gas
type, a conversion kit is required, available
from the Miele Spare Parts Department, (give
the model and serial number of the machine
as well as the local gas connection pressure).
The installation instructions for gas heated
machines must be followed. Conversion may
only be carried out by suitably competent per-
sons. Contact your nearest Miele Customer
Service Department or your Miele authorised
Service Dealer.
On first commissioning there can be air in the
inlet pipe, with no ignition taking place in the
first safety period. In this case the ignition
fault light comes on, and the "Reset" button
must be pressed in.
This renewed start procedure can be repea-
ted several times, until the air has been bled
and the burner flame burns.
Note:
If no flame signal appears during the safety
period, the valve shuts and the ignition is swit-
ched off, (malfunction cut-out with locking).
The "Reset" indicator light comes on. To un-
lock, press the Reset button.
After connecting the machine to the gas
supply any removable outer panels must
be back in place, and all moving or electri-
cal parts shielded before the machine is
switched on.
Do not attempt to undertake any repairs to
gas appliances yourself. Repairs must only
be carried out by suitably competent persons
to ensure safety, e. g. gas engineers must be
registered. Please consult the Miele
Customer Service Department or a Miele
authorised Service Dealer.

Exhaust ducting

Please refer to the Installation drawing and in-
structions supplied.
The connection point for the exhaust ducting
is situated at the rear of the right hand stand.
23 M.-Nr. 05372840