Blackstone 1555 Manual Del Usuario página 8

LP Tank Exchange
• Many retailers that sell grills offer you the option of
replacing your empty LP tank through an exchange
service. Use only those reputable exchange companies
that inspect, precision fill, test and certify their tanks.
Exchange your tank only for an OPD safety
feature-equipped tank as described in the "LP Tank"
section of this manual.
• Always keep new and exchanged LP tanks in upright
position during use, transit or storage.
• Leak test new and exchanged LP tanks BEFORE
connecting to grill.
• Place dust cap on cylinder valve outlet whenever the
cylinder is not in use. Only install the type of dust cap on
the cylinder valve outlet that is provided with the cylinder
valve. Other types of caps or plugs may result in leakage
of propane.
LP Tank Leak Test For Your Safety
•
Leak test must be repeated each time LP tank is
exchanged or refilled.
•
Do not smoke during leak test.
•
Do not use an open flame to check for gas leaks.
•
Tailgater must be leak tested outdoors in a
well-ventilated area, away from ignition sources such
as gas fired or electrical appliances.
•
During leak test, keep Tailgater away from open
flames or sparks.
•
Use a clean paintbrush and a 50/50 mild soap and
water solution. Brush soapy solution onto areas
indicated in figure below. Leaks are
indicated by growing bubbles.
WARNING
!
If "growing" bubbles appear do not use or move the LP
tank. Contact an LP gas supplier or your
fire department.
Do not use household cleaning agents.
to gas valve/hose/regulator components can result.
Connecting Regulator To The LP Tank
1. Place the LP tank on t
STONE Tailgater Combo between the supporting
right side legs.
2. Turn all control knobs to the OFF position.
3. Turn LP tank OFF by turning OPD hand wheel
clockwise to a full stop.
4. Remove the protective cap from LP tank valve.
Always use cap and strap supplied with valve.
Off Clockwise
Safety Relief Valve
5. Hold regulator and insert
nipple into LP tank valve.
Hand-tighten the coupling nut,
holding regulator in a straight line
with LP tank valve so as not to
cross thread the connection.
!
Nipple has to be centered
into the LP tank valve
Damage
8
he right side of the BLACK-
OPD Hand Wheel
Type 1 outlet with
thread on outside
Strap
Cap
Do not insert a POL transport
plug (plastic part with external
threads) into the Type 1 tank
valve outlet. It will defeat the
Safety Relief Valve feature.