Troubleshooting; Technical Data - Surtek SC507 Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• Keep the motor's air openings free from oil,
grease, and sawdust or woodchips, and store
the tool in a dry place.
• Be certain that all moving parts are well lu-
bricated, particularly after lengthy exposure to
damp and/or dirty conditions.
LUBRICATION
All of the bearings in this tool are lubricated
with a sufficient amount of highgrade lubri-
cant for the life of the tool under normal oper-
ating conditions. Therefore, no further lubrica-
tion is required.

TROUBLESHOOTING

IF THE BLADE DOES NOT FOLLOW A STRAIGHT
LINE:
• Teeth are dull. This is caused by hitting a hard
object such as a nail, and dulling the teeth on
one side. The blade tends to cut to the side
with the sharpest teeth.
• Base is out of line or bent.
• Blade is bent.
• Edge guide or straight edge is not being
used.
IF THE BLADE BINDS OR SMOKES FROM FRIC-
TION:
• Blade is dull.
• Blade is on backwards.
• Blade is bent.
• Workpiece is not properly supported.
• Incorrect blade is being used.
E N G L I S H •

TECHNICAL DATA

VOLTAGE-FREQUENCY
NO LOAD SPEED
BLADE DIAMETER
SPINDLE DIAMETER
CUTTING CAPACITY:
at 90˚
BEVEL CUTTING CAPACITY:
at 45˚ (Max.)
POWER
POWER CONSUMPTION
WEIGHT
U se r' s m a nu a l
120 V ~ 60 Hz
5 000 r/min
7 1/4" (185 mm)
5/8" (16 mm)
2 1/2" (63 mm)
1 3/4" (45 mm)
1 200 W
0,6 kWh
3,8 kg (8,3 lb)
21

Publicidad

Tabla de contenido
loading

Tabla de contenido