Onkyo TX-8250 Serie Manual De Instrucciones página 32

> Before Start > Part Names
BT Wakeup This function wakes up the unit on standby by connecting a
BLUETOOTH wireless technology enabled device.
"On": When this function is to be used
"Off (default value)": When this function is not to be used
0 When this setting is turned "On", power consumption
increases even when this unit is on standby, however, the
increase in power consumption is kept to a minimum by
automatically entering the HYBRID STANDBY mode, where
only essential circuits are operating.
0 The setting is fixed to "Off" if "6. Bluetooth" - "AutoChange" is
set to "Off".
Opt1Wakeup When an audio signal is input through the OPTICAL 1 terminal
while this unit is in standby, this feature automatically detects it.
"On ": This unit is turned on and outputs the audio.
"Off (default value)": The function is disabled.
0 When a cable is connected to the OPTICAL 1 terminal and
this setting is enabled, power consumption increases even
when the unit is on standby, however, the increase in power
consumption is kept to a minimum by automatically entering
the HYBRID STANDBY mode, where only essential circuits
are operating.
AM Freq Select a frequency step depending on your area of residence.
Select "9 kHz (default value)" or "10 kHz".
0 When this setting is changed, all radio presets are deleted.
DAB Auto Scan You can run the auto scan when new DAB stations are added or
when you move house.
0 This can not be set if a USB DAB adapter has not been
connected.
32
> Install > Initial Setup > Playback
Supplementary information |
DAB DRC With the DRC (Dynamic Range Control) setting, you can reduce
the dynamic range of DAB digital radio so that you can still hear
quiet parts even when listening at low volume levels - ideal for
listening to the radio late at night when you don't want to disturb
anyone.
"Off (default value)": DRC off
"Large": Large reduction in dynamic range
"Small": Small reduction in dynamic range
0 This can not be set if a USB DAB adapter has not been
connected.
Initialize DAB This initializes the USB DAB adapter. Initialize the USB DAB
adapter when disposing of it, giving it to another person, or if
operation becomes unstable.
1. Press ENTER when "Start" is displayed.
2. Select "Yes" with the Up/Down buttons on the remote
controller and press ENTER.
0 The scan information is deleted when you initialize the
adapter.
0 This can not be set if a USB DAB adapter has not been
connected.
4. Source
Intelli Adjust the volume level difference between the devices
connected to the unit. Select the input selector to configure.
Select from "-12 dB" to "+12 dB". Set a negative (j) value if the
volume of the target device is larger than the others and a
positive (i) value if smaller. To check the audio, start playback of
the connected device. (Default Value is "0 dB")
Name Edit Set an easy name to each input. The set name will be shown on
the main unit display. Select the input selector to configure.
For details on how to enter text, refer to "Entering text" (P15).
0 To name a preset radio station, press TUNER on the remote
controller, select AM/FM and select the preset number.
(Preset names cannot be given to DAB stations)
0 It cannot be set if the "NET" or "BLUETOOTH" input is
selected.
Advanced Setup | Others