IKA RV 10 control Instrucciones De Manejo página 52

Abbreviations used:
m = Numbering parameter (integer)
X = 2 Temperature heating bath
X = 3 Safety temperature heating bath
X = 4 Speed
X = 60 Interval time (1-99 seconds, 1 <= m >=99)
X = 61 Timer (1-199 minutes, 1 <= m >=199)
X = 62 Upper lift position (OUT_SP_62 1-> drive lift up)
X = 63 Lower lift position (OUT_SP_62 1-> drive lift down)
X = 66 Value vacuum controller
X = 70 Vacuum controller hysteresis
X = 74 Tempering medium (OUT_SP_74 0=Öl, OUT_SP_74 1=water)
NAMUR Commands Function
IN_NAME Request designation
IN_PV_X Read actual value
X = 4
IN_SOFTWARE Request software Id-number,
date and version
IN_SP_X Read target value input
X = 4
OUT_SP_X m Set target value to m
X = 1,60,61,62
RESET Switch to normal operation
START_X Switch on appliance (remote) function
X = 4,60,61,62
STATUS Status output
0:Manual operation without interruption
1:Automatic operation Start (without interruption)
ERROR z (z error number see table)
STOP_X Switch off appliance function. The variable
X = 1,60, 61, 62 set with OUT_SP_X remains
PC 1.1 Cable (Fig. 24)
This cable is required to connect the 9-pin connector to a PC. (fig. 24).
.
Fig. 24
52