Publicidad
Idiomas disponibles
Idiomas disponibles
AFTER EACH USE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump
parts and "freeze" pump action. Follow these
procedures after every use:
1.
Flush detergent siphoning tube by placing the filter
into a pail of clean water while running pressure
washer in low pressure mode. Flush for one to two
minutes.
2.
Shut off engine, let it cool, then remove all hoses.
3.
Disconnect spark plug wire from spark plug.
4.
Empty pump of all liquids by pulling recoil handle
about 6 times. This should remove most liquid in
pump.
5.
if storing for more than 30 days see "Long Term
Storage" on next page.
6.
Coil high pressure hose and inspect it for damage.
Cuts in hose or fraying could result in leaks and
loss of pressure. Should any damage be found,
replace hose. DO NOT attempt to repair a
damaged hose. Replace hose with genuine Sears
part.
7.
Disconnect hose from spray gun and high
pressure outlet on pump. Drain water from hose,
gun, and nozzle extension. Use a rag to wipe off
hose.
8.
Reconnect spark plug wire to spark plug.
9.
Store unit in a clean, dry area.
WARNING
WINTER
STORAGE
CAUTION
* Failure
to do so will permanently
damage
your pump
and render
your
unit inoperable.
, Freeze
damage
is not covered
under warranty.
To protect the unit from freezing temperatures:
1.
Flush detergent siphoning tube by placing filter
into a pail of clean water while running pressure
washer in low pressure mode. Flush for one to two
minutes.
2.
Empty pump of all pumped liquids by pulling recoil
handle about 6 times. This should remove most
liquid in pump.
3.
Use pump saver, available at Sears retail item
71-74403, to treat pump. This minimizes freeze
damage and lubricates pistons and seals.
4.
if pump saver is not available, connect a 3-foot
section of garden hose to water inlet adapter.
Pour RV-antifreeze
(antifreeze without alcohol)
into hose. Pull recoil handle twice. Disconnect
3-foot hose.
WHEN STORBNGFUEL OR EQUmPMENT WiTH FUEL IN
TANK
Store away from
furnaces,
stoves,
water
heaters,
clothes
dryers
or other
appliances
that have
pilot
light or other
ignition
source
because
they
can ignite
fuel vapors.
WHEN DRAINING FUEL
Turn pressure washer OFF and let it cool at least 2
minutes before
removing
fuel cap. Loosen cap
slowly
to
relieve pressure in tank.
Drain fuel tank outdoors.
Keep
fuel away from
sparks,
open
flames,
pilot lights,
heat,
and other
ignition
sources.
DO NOT
light a
cigarette or smoke.
18
Publicidad
