Publicidad
Idiomas disponibles
Idiomas disponibles
Yourpressure w asher requires someassembly a ndis
ready for useonlyafterit hasbeenproperly serviced
withthe recommended oil andfuel.
If you haveany problemswith the assemblyof
your pressure washer,pleasecall the pressure
washerhelplineat 1-800-222-3136.
REMOVE
PRESSURE
WASHER
FROM CARTON
•
Open carton and slice two corners from top to
bottom so the panel can be folded down flat.
°
Remove fillers, accessories and parts bag shipped
with your pressure washer.
•
Remove the pressure washer out the open end of
the carton.
•
Check carton for additional loose parts.
CARTON
CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
•
The main unit
•
High pressure hose
•
Spray gun
•
Nozzle extension with quick connect fitting and
nozzle holder
•
Safety goggles
•
Engine oil
•
Parts bag (which includes items listed below)
Owner's manual
Registration card
Bag containing 4 multi-colored
spray tips
Become familiar with each piece before assembling
the pressure washer. Compare contents against the
view on page 5. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
ASSEMBLING
YOUR PRESSURE
WASHER
Your Craftsman pressure washer was mostly assembled
at the factor},. However, you will need to perform these
tasks before you can operate your pressure washer:
1.
Add oil to engine crankcase.
2.
Add fuel to fuel tank.
3.
Connect high pressure hose to spray gun and pump.
4.
Connect water supply to pump.
5.
Select/attach quick connect spray tip to nozzle
extension.
Add Engine
Oil
CAUTION!
Any attempt to crank or start the engine
before it has been properly serviced with the
recommended
oil may result in an engine failure.
1.
Place pressure washer on a level surface.
2.
Clean area around oil fill and remove oil dipstick.
3.
Using oil funnel (optional), slowly pour entire
contents of provided oil bottle (18 oz.) into oil fill
opening.
4.
Replace oil dipstick and fully tighten.
NOTE: See the section "Oil" on page 15 to review oil
recommendations.
Add Fuel
NOTE: This engine is certified to operate on gasoline.
Exhaust Emission Control System: EM (Engine
Modifications).
WARNING
WHEN
ADDING
FUEL
Turn
pressure
washer
OFF and let it cool at least 2
minutes
before
removing
fuel cap. Loosen
cap slowly
to
relieve
pressure
in tank.
Fill or drain fuel tank outdoors.
DO NOT overfill
tank. Allow
space for fuel expansion.
Keep fue! away from sparks,
open flames,
pilot lights,
heat, and other
ignition
sources.
DO NOT light a cigarette
or smoke.
Use clean, fresh, regular UNLEADED fuel with a
minimum of 77 octane with equipment. DO NOT
use fuel which contains Methanol. DO NOT mix oil
with fuel.
2.
Clean area around fuel fill cap, remove cap.
3.
Slowly add regular unleaded fuel to fuel tank. Be
careful not to overfill. Allow about 1.5" of tank
space for fuel expansion, as shown here.
4.
InstaN fuel cap and wipe up any spiJJedfuel.
Publicidad
