Maintenance; Technical Data - Surtek SK403C Manual De Usuario Y Garantía

ADDITIONAL OPERATION ADVICE
POCKET CUTTING
The saw blade can be inserted directly into a
wood surface without first drilling a pilot hole
thus eliminating drilling operation.
First measure and clearly mark the surface to
be cut.
Then tip the saw forward
so that the rounded tips
of the shoe rest on the
work surface, but with the
blade well clear of it.
Switch ON and move the
saw in its tilted-up posi-
tion until the moving bla-
de is exactly over the chosen point of entry.
Lower the rear of the shoe toward the work
maintaining a firm pivoting.
Pressure in the shoe lips with the blade ex-
actly on lined NOT MOVE THE SAW FORWARD
ALONG ITS CUT until the saw blade has com-
pletely entered the material and the shoe
comes to rest flat on its surface.
SUGGESTIONS FOR PROPER USE
• Cut at an even rate and take care not to over
load the saw.
• Excessive force on the saw will prevent the
pendulum action operating correctly and re-
duce the cutting efficiency.
• When cutting tight curves, reduce or switch
off the pendulum align.

MAINTENANCE

NOTE: Be sure to switch power OFF and discon-
nect the plug from the receptacle during main-
tenance and inspection.
1. Periodically clean all dust and wood chips
from around and under the base. Even though
slots are provided to allow debris to pass
through, some dust will accumulate.
2. The brushes are designed to give you several
years of use. If they ever need replaced follow
the instructions in this manual or return the
tool to the nearest service center for repair.
10

TECHNICAL DATA

VOLTAGE-FREQUENCY
SPEED
CUTTING CAPACITY;
Wood
Aluminium
POWER
WEIGHT
120 V ~ 60 Hz
(0 - 3 000) r/min
3 1/8" (70 mm)
5/16" (8 mm)
600 W
2 kg (4,6 lb)