Kenmore 363 Manual De Uso Y Cuidado página 16

ICE TRAYS
(on models without automatic icemaker)
To release ice cubes, turn
the tray upside down, hold
it over a container, and twist
both ends,_
For only one or two ice
cubes, leave the tray right_
side up, twist both ends
slightly, and remove as many
cubes as you want°
Wash ice trays in lukewarm water only, Do not put
them in an automatic dishwasher.
AUTOMATIC ICEMAKER ACCESSORY KIT
(optionalat extra cost)
If your refrigerator did not come already equipped with
an automatic icemaker, you may add one--contact your
Sears store or Sears Service Center.
AUTOMATIC ICEMAKER
(on icemaker-equipped models)
If your refrigerator is
operated before water is
connected to the
icemaker, keep the
icemaker feeler arm in the
STOP (up) position,,
When the refrigerator has
been connected to the
water supply and the
water has been turned
on, move the ice storage
bin into place under the
icemaker. Then move
the feeler arm to the ON
(down) position.
The ice cube mold will
automatically fill with water
after cooling to freezing
temperature, and first
cubes normally freeze after
several hours.
Icemaker Feeler Arm
in STOP (up)
position
!_rage
Bin
Feeler Arm in
ON (down)
.,'_. ti position
/
When cubes are solidly frozen, they will be ejected from
the mold into the ice storage bin by means of a sweeper
arm. Icemaking will continue until the feeler arm senses
that there are enough cubes in the bin and halts the
operation temporarily. Be sure nothing interferes with the
swing of the feeler arm,
For maximum ice storage, level the stored cubes with
your hand occasionatly_
Once your icemaker is in operation, throw away the
first few batches of ice cubes. This will flush away any
impurities in the water line. Do the same thing after
vacations or long periods when ice isn't used.
Move feeler arm to STOP (up) position when:
• the home water supply is to be off for several hours,
• the ice storage bin is to be removed for a period
of time.
• going away on vacation. (Also turn off the valve in the
water supply line to the refrigerator.)
• turning the temperature control to the OFF position,
If ice is not used often, old cubes will become
cloudy and taste stale. Empty the ice storage bin
periodically and wash it in lukewarm water.
tf this is your first icemaker, you will hear occasional
sounds that may be unfamiliar° They are normal ice-
making sounds and are not cause for concern.
WATER FILTER
ACCESSORY
(optional at extra cost)
Your ice cubes can only be as fresh-tasting as the water
that produces them. That's why it's a good idea to purify
the water with a water filter,
The water filter is an optional part at extra cost and is
available from your Sears Service Center° Order Filter
No, 978488 and it may be installed in minutes when
attached to the inlet water tube connection°
WATER SUPPLY ACCESSORY KIT
(optional at extra cost)
A water supply kit containing copper tubing, shut-off
valve, fittings and instructions needed to connect the
icemaker to your co_d water line is also available from
your Sears store or Sears Service Center,,
16