Urrea CC910 Manual De Usuario Y Garantía página 21

· Lock the miter guide securely to the table by
turning the miter guide knob clockwise.
To adjust angles:
· Loosen the lock knob.
· Set to the desired angle by moving the
guide left or right.
· Tighten the knob securely before turning on
the saw.
A. Miter guide knob
B. Miter guide
TILE CUTTING WHEEL
For maximum performance and safety, it is
recommended that you use the 10 in. cutting
wheel.
WARNING: Do not use cutting wheels
rated less than the no load speed of this
tool. Failure to heed this warning could re-
sult in personal injury. Do not use wheel with
cracks, gaps, or teeth.
INSTALLING TILE CUTTING WHEEL
· Unplug the saw.
· Turn the wheel guard lock counterclockwise
to unlock.
· Pull the wheel guard open to expose the
spindle.
· Place a washer onto the spindle. Be sure the
hollow side of the blade washer faces the tile
housing.
· Wipe a drop of oil onto the washer where it
contacts the cutting wheel.
WARNING: A 10 in. tile cutting wheel is the
maximum wheel capacity of the saw. Larger
wheels will come in contact with the wheel
guard, while thicker wheels will prevent the
wheel bolt from securing the wheel on the
spindle. Either of these situations could result
in a serious accident and can cause serious per-
sonal injury.
C. Lock knob
D. Sliding table extension
E N G L I S H •
A. To loosen
B. To tighten
C. Tile cutting wheel
D. Wheel wrench
D
WARNING: If the washer has been removed,
replace it before placing wheel on spindle.
Failure to do so could cause an acci- dent since
the wheel will not tighten properly. Never use
wheels that have openings, grooves, or teeth
on this tool.
· Slide the cutting wheel onto spindle.
· Place a washer onto the spindle. The double
"D" flats on the washers align with the flats
on the spindle. Be sure the hollow side of the
blade washer is against the cutting wheel.
· Place wheel nut on spindle.
· Depress the spindle lock button and rotate
the cutting wheel until the spindle locks.
· Using the wheel wrench provided, tighten
nut securely.
Release the spindle lock button.
· Close and lock the wheel guard.
A. Inner washer
B. Outer washer
U se r's m a nua l
E. Wheelguard lock
F. Spindle lock
E
C. Wheel nut
A
B
C
21