Maintenance; General Maintenance - Urrea CC910 Manual De Usuario Y Garantía

· Tighten the bevel lock knob.
If the cutting wheel is not an exact 45°:
· Set the saw arm to a 45° angle.
· Place a combination square beside the wheel
and set the saw arm at 45°.
· Using a wrench, turn the 45° hex bolt until
the hex bolt is resting on the saw housing.
After squaring adjustments have been made,
it may be necessary to loosen the indicator
screw on the bevel scale indicator and reset it
to zero.

MAINTENANCE

WARNING: When servicing, use only identi-
cal replacement parts. Use of any other parts
may create a hazard or cause product damage.
WARNING: Always wear eye protection
with side shields marked to comply with ANSI
Z87.1 during product operation. If operation is
dusty, also wear a dust mask.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to damage
from various types of commercial solvents and
may be damaged by their use. Use clean cloths
to remove dirt, dust, oil, grease, etc.
WARNING: Do not at any time let brake
fluids, gasoline, petroleum-based products,
penetrating oils, etc., come in contact with
plastic parts. Chemicals can damage, weaken
or destroy plastic which may result in serious
personal injury.
LUBRICATION
All of the bearings in this tool are lubricated
with a sufficient amount of high grade lubri-
cant for the life of the unit under normal oper-
ating conditions. After extended use, clean the
rails so the table will slide smoothly.
BRUSH REPLACEMENT
The saw has externally accessible brush assem-
blies that should be periodically checked for
wear
Proceed as follows when replacement is re-
quired:
· Unplug the saw.
26
WARNING: Failure to unplug the saw could
result in accidental starting causing serious
injury.
· Remove brush cap with a screwdriver. Brush
assembly is spring loaded and will pop out
when you remove brush cap.
A. Brushes cap
· Remove brush assembly.
· Check for wear. Replace both brushes when
either has less than 1/4 in. length of carbon
remaining. Do not replace one side without
replacing the other.
· Reassemble using new brush assemblies.
Make sure
curvature of brush matches curvature of motor
and that brush moves freely in brush tube.
· Make sure brush cap is oriented correctly
(straight) and replace.
· Tighten brush cap securely. Do not over-
tighten.
CLEANING THE RAILS
During use, the rails will become dirty prevent-
ing the table rollers from sliding smoothly. It is
important to clean the rails often.
CLEANING THE SUBMERSIBLE PUMP
· Unplug pump before handling or cleaning
the pump.
· Remove the front cover.
· Using a small brush and/or water, clean any
debris or trash that is trapped on the inside of
the pump.
NOTE: To maintain efficiency and extend the
life of the pump, check intake screen before
use to make sure it is clean.
· Rinse filter with clean water
B. Brushes assembly