Urrea CC910 Manual De Usuario Y Garantía página 24

· Place the material on the table and firmly
against the miter guide and fence.
· Make sure the material is clear of the cutting
wheel before
turning on the saw.
· Turn the on/off switch to the ON position.
· Let the cutting wheel build up to full speed
and wait for the wheel to get wet before mov-
ing the material into the wheel.
· Hold the material firmly against the miter
guide and feed the material into the cutting
wheel.
· Make the cut far enough into the material
without over- cutting.
· When the cut is made, turn the saw OFF. Wait
for the cutting wheel to come to a complete
stop before remov- ing any part of the mate-
rial.
· Turn the material over and make the cut
along one of the marks. This time overcut the
other line and the cut piece
should separate from the rest of the material.
· When the second cut is made, turn the saw
OFF. Wait for the cutting wheel to come to a
complete stop before removing any part of the
material.
TO MAKE A BEVEL CUT
Beveled cuts can be made at 22.5° or 45°
angles.
· Using a marker or grease pencil, mark the
area to be cut on material.
· Loosen the bevel lock knob and move the saw
arm to the desired bevel angle.
· Place the miter guide on the right side of the
table at the desired distance from the wheel
and lock in place.
· Make sure the material is clear of the cutting
wheel before turning on the saw.
· Turn the on/off switch to the ON position.
· Let the cutting wheel build up to full speed
and wait for the wheel to get wet before mov-
ing the material into the wheel.
· Hold the material firmly against the miter
24
guide and fence and feed the material into the
cutting wheel.
· When the cut is made, turn the saw OFF. Wait
for the cutting wheel to come to a complete
stop before removing any part of the material.
TO MAKE A PLUNGE CUT
Plunge cuts are made by positioning the mate-
rial directly underneath the cutting wheel and
lowering the wheel onto the workpiece. This
allows pieces to be cut from the center of the
material.
· Using a marker or grease pencil, mark the
area to be cut on material.
· Loosen the lock knob on the top of the motor
head and position the motor head upward to
its maximum height. Tighten the lock knob.
· Secure the material on the table underneath
the cutting wheel.
· Turn the on/off switch to the ON position.
· Let the cutting wheel build up to full speed
and wait for the wheel to get wet before mov-
ing the material into the wheel.
· Hold the motor head firmly by the handle.
· Slowly lower the motor head into the mate-
rial to make the cut.
· Raise the motor head.
· Turn the on/off switch to the OFF position.
· Turn the flow adjustment valve to the OFF
position.
· Slide the table away from the motor head
and position the work material for the next
cut.