GETTING TO KNOW YOUR MR. COFFEE
ESPRESSO MACHINE
Brew Button
with Indicator Light (blue)
Clear-View, Removable
Water Reservoir with Lid
Brew Head
Measuring
Scoop/
Tamper
Stainless Steel Frothing Pitcher
(included with certain models)
Replacement parts & accessories available on mrcoffee.com
6
®
Pulses when pressed &
Steam Button
turns solid when unit is
Indicator Light (blue)
ready to use
Filter
Retainer Clip
Frothing
Wand
Removable Frothing
Removable Drip Tray
Cord Storage
(back of unit)
Single Shot and Double
Single & Double-Shot
Shot Filters included
Ceramic Espresso Cup
(included with certain models)
INTRODUCTION
Congratulations! You're the proud new owner of a Mr. Coffee
Soon you'll be brewing real espresso drinks just like the coffee shop.
Now, let's get started.
UNPACK YOUR ESPRESSO MACHINE
1.
Remove the machine from the box.
2.
Remove all plastic bags and tape holding items in place.
3.
Remove and save literature for future reference.
4.
Untwist the tie holding the power cord.
5.
There may be a few water drops in the reservoir. This is normal; we test each unit with
Control Knob
filtered water.
BEFORE FIRST USE, CLEAN AND PRIME YOUR MACHINE
Portafilter
Cleaning and priming your Mr. Coffee
process. Please follow these simple steps before brewing coffee for consumption:
2
Wand Cover
5
On/Off (I/0)
Switch
8
NOTE:
Please note that noise during brewing or steaming is normal due to the 15-bar Italian
pump that is inside the machine.
Now your espresso machine is ready to use!
espresso machine before its first use is a critical
®
1.
Wash all removable parts with warm soapy water.
2.
Place machine on flat level surface.
3.
Remove red plug from the bottom of the water tank.
4.
With the filter retainer clip in the downward position, place an empty filter
into the portafilter.
Insert portafilter underneath brew head so that the handle lines up with
5.
on the unit and fits into position.
Then, slowly turn the handle to the right until it lines up with the
6.
points directly to you when standing in front of the machine.
Remove lid and fill water reservoir with filtered water. Do not exceed the
7.
"Max" mark.
Plug in your machine and press the switch side to on
8.
Brew Button
blue indicator light is on.
9.
Place a large empty cup under the portafilter when the blue light is solid.
10.
Turn knob to brew and wait for water to cycle through unit and dispense.
11.
Turn control knob to stop when ½ a cup is filled.
12.
Place empty cup under frothing wand.
13.
Press steam button
.
14.
When steam button turns solid blue, turn knob to steam for 10-15 seconds.
Then, turn knob to stop
.
15.
Discard water in sink.
16.
Turn unit off.
espresso machine.
®
and
. Make sure the
7