Align the rear cylinder cover onto the main body.
To replace the cylinder, make sure that its tap is closed and that there are no open flames (lit oven,
etc.) or sources of heat in the place where you are working.
The hose used for this appliance must be replaced every two years.
Check the gas hose once per month and each time the cylinder is changed, if it shows cracking,
splitting or other deterioration, it should be replaced with a new one.
To not mishandle the connections or other components.
Do not turn the cylinder upside down to completely use its contents: this releases liquid residues
left in the tank that will irreparably damage the heater.
OPERATING INSTRUCTION
WARNING: ALWAYS ACCESS THE CONTROLS AND CYLINDER VALVE FROM THE SIDE OR THE
REAR OF THE HEATER. DO NOT ATTEMPT TO RE-LIGHT UNTIL 5 MINUTES HAVE ELAPSED.
TO LIGHT THE HEATER
The device's for turning-on and regulating the heater are located on the upper part.
Open the valve on the gas cylinder.
Turn the regulation knob to pos. .
seconds, also the piezoelectric button several times contemporaneously until the atmosphere
analyser flame. Hold down the knob for 20 seconds from the lighting of the flame, then release the
knob; if the flame should go out, repeat the operation.
Release the handle and turn it to the position corresponding to the desired amount of heat:
Piezoelectric Buttom
Pos.2: Medium
To turn off the appliance, please completely shut off the valve at the gas container.
Do not hold the knob at position one for longer than 40 seconds.
Do not move the heater when it is operating.
After use, please turn off the appliance at gas cylinder valve.
(max+starter) press it all the way down and after around 10
Pos.1: Ignition/Maximum
Pos.3: Minimum
- 17 -
GB
Control Knob