Part Description; Tools Needed - Kobalt 0857432 Manual De Instrucciones

PREPARATION
PART DESCRIPTION
A ON/OFF switch
B Motor housing
C Handle
D Live-tool indicator
E Fixed base
F Spindle-lock button
G Collet/nut
H Sub-base
I Chip guard
J Replaceable brush cap
K Micro-fine adjustment dial
L Depth-indicator ring
WARNING
• The safe use of this product requires an understanding of the information on the tool and
in this operator's manual, as well as knowledge of the project you are attempting. Before
attempting to use any tool, be sure to become familiar with all of the operating features and
safety rules. Do not allow familiarity with the tool to cause carelessness. Remember that one
careless moment is enough to cause severe injury.

TOOLS NEEDED

The following tools (not included) are needed for assembly or making adjustments.
Phillips Screwdriver
8 Open-end Wrench
PART DESCRIPTION
M Above-table depth adjustment nut
N Motor clamp
O Coarse-adjustment knob
P Edge-guide locking knobs
Q Edge-guide mounting slots
R Vacuum adaptor
S In-feed fence
T Out-feed fence
U Feather boards
V Miter gauge
W Integrated safety switch
X Fastening holes
13