Safety Instructions - HAIRCUT TH37 Manual De Utilización

PROFESSIONAL CORD CLIPPERS
EN

1.5. Safety instructions

Electrical hazards
 Make sure that the power supply voltage
shown on the nameplate (Fig. 2) of the
clippers corresponds to that of your
electrical installation.
 To provide additional protection, it is
recommended to install a rated residual
differential current device (RDD) not
exceeding 30 mA in the electrical circuit
supplying the equipment. Request
advice from your installer.
 Regularly check the condition of the
electrical lead. If the lead shows any
signs of damage, stop using the
equipment immediately. Contact the
dealer or his after-sales service to obtain
a replacement lead.
 In the event of failure of the charge stand
or power pack, it must be replaced by a
model that is identical in all respects.
 The electrical lead must always be fully
unrolled before it is connected to a
power socket.
13