Test Light Instructions; Battery Disposal - Petsafe PDT20-12471 Manual De Funcionamiento

Test Light Instructions

Note: If the Test Light does not fl ash, recharge the battery and re-test. If Test Light still does not fl ash,
contact the Customer Care Centre or visit our website at www.petsafe.net.
Important: The Test Light Tool can be used to tighten the Contact Points. This Receiver Collar
has special waterproof Contact Points that will crack if they are over-tightened. If your Contact
Points ever become loose, do not turn them any more than one-quarter turn beyond fi nger tight.
_____________________________________________________________________________________

Battery Disposal

Separate collection of spent batteries is required in many regions; check the regulations in your
area before discarding spent batteries. The Remote Transmitter operates on one battery of the type
Nickel Metal Hydride (NiMH) with a 7.2 Volt, 160 mAH capacity. The Receiver Collar operates
on one battery of the type NiMH with a 4.8 Volt, 120 mAH capacity.
At end of product life, use these battery removal instructions for fi nal disposal of the
battery pack.
• Using a number 1 Phillips screwdriver, remove the case screws.
• Remove the case back or cover.
• Remove the old battery pack.
Note: When removing the old battery pack, care must be taken when gripping the connector fi rmly to
avoid damaging the wires. Shorting the battery wires may cause fi re or explosion. These instructions are
not valid for repair or battery replacement. Replacing the battery with a battery not specifi cally approved
by Radio Systems Corporation
avoid voiding your warranty. For a listing of Customer Care Centre telephone numbers, visit our web site
at www.petsafe.net.
WARNING
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
16
400-1158-19.indd 16 400-1158-19.indd 16
1. Turn the Receiver Collar on.
2. Hold the Test Light Contacts to the Contact Points.
3. Press a Stimulation Button on the Remote Transmitter.
4. The Test Light will fl ash.
Note: At higher Stimulation Levels, the Test Light will
fl ash brighter.
5. Turn the Receiver Collar off.
Save the Test Light for future testing.
® may cause fi re or explosion. Please contact the Customer Care Centre to
www.petsafe.net
9/25/09 10:41:05 AM 9/25/09 10:41:05 AM