Operating Determinations - Futurelight PRH-Digital Manual Del Usuario

running, the device must be checked by a specialist if the liquid has reduced any insulation. Reduced
insulation can cause mortal electrical shock.
There must never be any objects entering into the device. This is especially valid for metal parts. If any metal
parts like staples or coarse metal chips enter into the device, the device must be taken out of operation and
disconnected immediately. Malfunction or short-circuits caused by metal parts may cause mortal injuries.
Keep away children and amateurs!
Never leave this device running unattended.

OPERATING DETERMINATIONS

This device is a DMX-controlled rotating holder i.e. for mounting and operating LCD and plasma screens,
smoke machines and lighting effects. This product is only allowed to be operated with an alternating current
of 230 V, 50 Hz and was designed for indoor use only.
This device is designed for professional use, e.g. on stages, in discotheques, theatres etc.
This device is not designed for permanent operation. Consistent operation breaks will ensure that the device
will serve you for a long time without defects.
Do not shake the device. Avoid brute force when installing or operating the device.
Never lift the device by holding it at the plate, as the mechanics may be damaged. Always hold the device at
the transport handles.
Never place any object on the housing of the device.
Make sure that power cables, chains, neckties, cords or long hair and beards will not get
between the base and the plate inorder to avoid entanglement due to the plate rotation.
Max. dimensions of mountable objects (LxWxH): 860 x 640 x 150 mm.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. Please make sure that the unit cannot be
touched or bumped. You endanger your own and the safety of others!
This device must never be operated or stockpiled in sourroundings where splash water, rain, moisture or fog
may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical
shocks.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
Entanglement hazard!
The maximum load must never be exceeded!
Max. tearing load: 80 kg, max. pressing load: 80 kg,
The load must always be installed in the centre of gravity!
CAUTION!
CAUTION!
29/90 00029992.DOC, Version 1.3