Control Board - Futurelight PRH-Digital Manual Del Usuario

Control Board

The Control Board offers several features: you can simply set the starting address, switch on and off the
safety power outlet, run the pre-programmed program or make a reset.
The main menu is accessed by pressing Mode/Esc until the display is lit. Browse through the menu by
pressing Up or Down. Press Enter in order to select the desired menu. You can change the selection by
pressing Up or Down. Press Enter in order to confirm. You can leave every mode by pressing Mode/Esc.
The functions provided are described in the following sections.
Default settings shaded.
Main menu
Set DMX address
Value display
Function
Set to Slave
Mode
Auto program
Music control
Time information
Software version
Switch on or off
Automatic PW-on
Switch on DMX
Switch off DMX
Status settings
Display setting
Initial effect
Reset default
Reset All
Reset
function
Reset PAN
Sub menu
A001~ AXXX
PAN ...
Slave 1, Slave 2,
Slave 3
Master/Alone
Master/Alone
Current time
Total run time
Clear total time
Ver. 1.0
ON/OFF
ON/OFF
ON/OFF
ON/OFF
Address via DMX
No DMX status
PAN reverse
Fine resolution
Movement speed
Mic sensitivity
Shutoff time
PAN ...
ON/OFF
41/90
Display
XXXX (hours)
XXXX (hours)
ON/OFF
ON/OFF
Hold
Initial/ /Auto/Music
ON/OFF
ON/OFF
Speed 1 ~ 4
70 %, 0~99%
05M, 01M-59M
PAN = XXX ...
00029992.DOC, Version 1.3
Function
DMX address setting
DMX value display
Slave setting
Auto program
Music control
Individual fixture
running time
Fixture running time
Clear fixture running
time
Software version of
each IC
Power outlet on/off
Power outlet on/off/
Power switch
Power outlet on via
DMX
Power outlet off via
DMX
Addr. via DMX
Run if no DMX
PAN reverse movement
16-bit movement switch
from 16 bit to 8 bit
resolution
Adjust PAN speed
Mic sensitivity
Display shutoff time
Initial effect position
Restore factory sett.
Reset all motors
Reset only PAN