Surtek LE612 Manual De Usuario página 12

IMPORTANT: The illustrations shown next
are for reference only.
IMPORTANT: Sanding operations are inher-
ently dusty. It is strongly recommended that
users use a dust-collection system when using
this belt & disc sander. The use of a mask or
respirator is still recommended even when a
dust-collection system is in use.
4
5
6
8
7
1. Belt tracking control knob.
2. 4"x 36" Sanding belt.
3. Backstop.
4. Quick release belt tension lever.
5. Belt drive drum.
6. Built-in dust port.
7. Adjustable mitre gauge.
8. Cast aluminum tilting work table.
9. 6" Sanding disc.
10. On/off Switch.
11. Cast iron base with mounting holes.
ASSEMBLY
CAUTION: The sander must be assembled
before use. Do not plug unit into power source
until the unit has been completely assembled.
MOUNTING THE SANDER TO A WORKBENCH
Before attempting to use this sander, it should
be properly mounted to a workbench or stand
1. Position the sander on the workbench where
you intend to use it.
2. Mark the work-
bench through the
mounting holes lo-
cated in the sander
base. Drill holes in
the workbench at the
marks.
12
3
2
1
11
10
9
Bolt.
Bolt.
Hex
Spring
nut.
washer.
3. Use long bolts, spring washers and nuts (not
supplied), to secure the sander to the work-
bench as shown.
MOUNTING THE TILTING WORK TABLE ASSEMBLY
1. Position table-sup-
port bracket so that
the "pivot pin" fits
into the correspond-
ing hole on the sander
frame and the radius
slot aligns with the
threaded hole in the
frame.
2. Place washer on threaded shaft of knob,
insert through radius slot, and tighten into
threaded hole.
3. Adjust table to angle desired for sanding
task.
4. To avoid trapping the workpiece or your
fingers between the table and disc, adjust the
position of the table on it's mounting bracket
to maintain a gap of no more than 2 mm.
INSTALLING THE BACKSTOP
1. Position the back-
stop against the belt
frame so that the slot
aligns with threaded
hole in frame.
2. Secure the back-
stop to frame with 2
x socket head screws,
washers as shown. Do
not overtighten.
• The gap between the sanding belt and the
backstop should be no more than 2 mm.
ATTACHING A DUST COLLECTION HOSE
This sander is equipped
with a 2½" (60 mm) di-
ameter dust port that
can be connected to a
vacuum or dust collec-
tion system.
1. Place a 2½" ID diameter hose over the dust
port. Secure hose in place with a hose clamp.
CHANGING THE SANDING DISCS
WARNING: Turn the power off and remove
the plug from the outlet before changing the
accessories.
Flat
washer.
Knob.
Pivot pin.
Table
support.
Flat washer.
Socket head
screw.
Hex wrench.
Dust
port.