On/Off Buttons - Surtek LE612 Manual De Usuario

ON/OFF BUTTONS

The On/Off buttons are located on the front
of the sander.
1. Press the GREEN button (I) to turn the sander
on.
2. Press the RED button (0) to turn the sander
off.
· If the power supply is interrupted for any
reason, the unit will automatically switch off.
When power is restored, simply press the
GREEN button to resume work.
BELT SANDING
HORIZONTAL AND VERTICAL SANDING
The sanding belt can be used in the vertical or
horizontal position, depending on operator
needs and the workpiece.
To change from one position to the other:
1. Loosen the socket head screw using the 6
mm hex wrench provided.
2. Manually move the sanding belt to the
desired angle and retighten the socket head
screw.
Socket head
screw.
SURFACE SANDING ON THE BELT
When sanding flat broad surfaces on the belt
hold the workpiece firmly on the surface of the
belt and against the backstop, keeping fingers
away from the sanding belt. Consider using a
push or hold-down stick.
Backstop.
- Use extra caution when sanding very thin
pieces, and when sanding extra long pieces,
remove the backstop.
14
Vertical.
Work piece.
NOTE: When using the sander without the
backstop, ensure that you have a firm hold on
the workpiece at all times and take extra care.
- Apply only enough pressure to allow the
sanding belt to remove material.
SANDING CURVED PIECES
When sanding inside-curves on the belt sander,
always sand on the idler drum end of the belt.
1. Hold the workpiece firmly, keeping fingers
away from the sanding belt. Keep the curve
pressed firmly against the idler drum, mov-
ing the work evenly back and forth across the
drum.
SANDING DISC
SANDING OUTSIDE CURVES
Always sand outside curves using the sand-
ing disc and moving the workpiece from the
left side of centre, as shown. Keep the curve
pressed firmly against the sanding disc, moving
the work evenly from the left side of the sand-
ing disc. Be sure to hold the workpiece firmly
against the surface of the table.
MITRE GAUGE - DISC SANDER
A mitre gauge can be used on the work table,
as shown. The mitre gauge head can be set
anywhere up to 60˚ (right or left) by loosening
the lock-knob, setting the mitre gauge head
to the desired angle, and tightening the lock-
knob.
Miter lock knob.
Work piece.
Idler drum.
Work piece.
Work piece.