Zone Outputs (Zone 2,3,4); Operating The Rsp-1572; Front Panel Overview; Front Panel Display - Rotel RSP-1572 Manual De Instrucciones

24

Zone Outputs (ZONE 2,3,4)

This Rotel processor has connections for three independent remote
zones.
For audio connections to a remote zone, connect the left and
right ZONE 2,3, or 4 jacks to the left and right channels of a remote
zone amplifier with an RCA audio cable.
For video connections to a remote zone, connect the ZONE 2,3,
or 4 VIDEO OUT jacks to the input of a TV in the remote zone using a
Composite Video cable.
For control of the unit from a remote zone: connect a remote
zone IR repeater to the ZONE 2, ZONE 3, or ZONE 4 REM IN jack
using a cable terminated with 3.5mm plugs.
RSP-1572 SURROUND SOUND PROCESSOR

Operating the RSP-1572

Considering its large number of features, settings and options, this Rotel
RSP-1572 is remarkably easy to operate. The key to operating the unit
is its system of On-Screen Displays (OSD) which guide you through
various choices.
To guide you through the operation of the unit, this section of the manual
starts with explaining the basic layout and function of the front panel and
the remote control. Then, we explain the basic operations such as turning
the unit on and off, adjust volume, selecting a source for listening, etc.
Following that is a detailed explanation of surround sound modes and
how to configure the unit for various types of recordings. Finally, there
are instructions for additional features and zone operation. All of these
are features that may be used in normal operation. The last section of
the manual (Configuration) details options that may be selected during
initial setup and configuration of the unit, many of which will be set once
and left untouched.
Throughout this manual, numbers in square boxes refer to the main unit
illustration at the front of this manual. Letters refer to the remote handset
illustration. When both appear, the function is found on both the unit's
front panel and on the remote. When only one appears, that function is
found either only on the main unit, or only on the remote.

Front Panel Overview

The following is a brief overview of the controls and features on the front
panel of the unit. Details concerning the use of these controls are provided
in subsequent sections of this manual describing various tasks.

Front Panel Display

2
The FL Display on the front panel shows the source selected and type of
audio mode the unit is in.

Remote Sensor

2
This sensor receives IR signals from the remote control. Do not block this
sensor. The IR sensor is behind the front panel display.
Note: The remainder of the buttons and controls on the front panel are
described in the Overview of Buttons and Controls section.

Remote Control Overview

The RSP-1572 is supplied with an easy to use remote control RR-CX94.
The unit can be set to IR code 1 or IR code 2 in case the unit is conflicting
with other Rotel remote codes. Push the TUN key and 1(2) at the same
time sets the remote control into IR code 1(2). Point the remote to the
RSP-1572 and press 1(2) for 5 seconds sets the RSP-1572 in IR code
1(2). The factory default is IR code 1.
The supplied remote can also be set to control zones 2,3 and 4 from the
main room by setting the remote to IR codes 3, 4 or 5. Set to IR code 3,
4, or 5 by pressing TUN key and 3 (4 or 5) at the same time. IR code
3 is for Zone 2. IR code 4 is for Zone 3 and IR code 5 is for Zone 4
operation.