Zanussi ZHC4284 Manual De Instrucciones página 11

Charcoal Filters
Enabling the alarm signal
• In Recirculation version Hoods, the Filter saturation alarm can be enabled on installation or at a later date.
• In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on installation or at a later date.
• Turn the Lights and the Suction Motor off.
• Press button T2
4 months. The alarm signal will only light up when the extractor motor is switched on.
To Remove/Replace the Charcoal Filters
• Open the lighting unit by pulling on the notch.
are not cleaned and replaced as recommended.
Alarm signal reset
• Switch off the lights and extractor motor.
• Press T3 and hold for at least 3 seconds, until LED
Changing the halogen light
and pull it out of from the Hood.
• Extract the lamp from the Support.
• Replace with another of the same type, making sure
that the two pins are properly inserted in the lamp
holder socket holes.
screws removed as above.
Lamp Power (W)
GB
MAINTENANCE AND CLEANING
Socket Voltage (V)
GU4
S1
Dimension (mm) ILCOS Code
11