10
Adaptation to the circle cutter
The circle cutter can be used to create circular cuts
with a diameter between 120 and 3000 mm. The cir-
cle cutter can be installed from both sides on the
adaptation table.
Place the jigsaw with attached adaptation table
on the adapter [11-1] on the circle cutter.
Insert the centring mandrel [11-2] in the hole
[11-4] on the circle cutter aligned with the saw
blade.
Clamp the measuring tape to the circle cutter
using the rotary knob [11-5].
Recommended when using the circle cutter:
Cut in an anticlockwise direction.
Work at a slow rate of advance.
Set the pendulum stroke [1-12] to 0 - 1.
Set the stroke rate [1-5] to 1 - 5.
Store the centring mandrel in the depot [11-3].
KS-PS 400
11-1
11-5
11-4
Systainer
Systainer
Many Festool products are shipped in a unique sys-
tem container, called "Systainer". This provides
protection and storage for the tool and accessories.
The Systainers are stackable and can be inter-
locked together. They also can be interlocked atop
Festool CT dust extractors.
To open the Systainer
Turn the T-loc [12-1] to this position.
To lock the Systainer
Turn the T-loc [12-1] to this position.
To connect two Systainers
Place one Systainer on the top of the other (Fig. [12
A]).
Turn the T-loc [12-1] to one of this posi-
tions (Fig. [12 B]).
The Systainers are connected and locked.
A new generation Systainer is connectable on
top of a previous generation Systainer by the
four latches of the previous Systainer.
11
11-2
11-3
17