English - Best Gloss Instrucciones De Uso

English

! The appliance must be installed by a qualified person in
compliance with the instructions provided.
!
Wear gloves when carrying out installation and
maintenance operations.
AIR VENT
(for ducting versions)
! Prepare the hole and the air vent duct (150 mm
diameter).
! Use a duct of the minimum indispensible length.
! Use a duct with as few elbows as possible (maximum
elbow angle: 90°).
! Avoid drastic changes in the duct cross-section.
! Use a duct with an as smooth as possible inside.
! The duct must be made of certified material.
! Do not connect the hood to smoke exhaust ducts for
the products of combustion (boilers, fireplaces, stoves,
etc).
! For the air vents comply with the provisions laid down
by the competent authorities.
In addition, the air must not be evacuated through a
hole in the wall unless specifically intended for this
purpose.
! Fit air intakes in the room to prevent the hood from
creating a negative pressure in the room (which must
not exceed 0.04 mbar); if the hood is used at the same
time as non-electrical equipment (gas-, oil- and
charcoal-fired stoves, etc.) the exhaust gas may be
sucked in by the heat source.
FILTERING OR DUCTING VERSION ?
The hood may be in filtering or in ducting version.
Decide from the outset which type is to be installed.
For better efficiency, we recommend installing the hood
in the ducting version (if possible).
Ducting version
The hood purifies the air and evacuates it to the outside
through an exhaust duct (diameter 150 mm).
Filtering version
The hood purifies the air and recycles the clean air back
into the room. For this version, the following are required:
1 air baffle, 1 reducer, 1 charcoal filter.
The upper flue air evacuation slots must be positioned at
the top.
12
CONTROLS
A) Turns the LIGHTS off
B) Turns the LIGHTS on.
C) Decreases speed down
to minimum speed. If
pressed for 2" the motor is
turned off.
D) Activates the motor
(calling the last speed
used) and increases the
speed until reaching
maximum.
E) FILTER ALARM/TIMER
RESET: when pressing the
key during display of the
filter alarm (motor off) it
resets the hour counter.
When pressing the key
when the motor is running,
the TIMER is activated and
the hood will automatically
be switched off after 5
minutes.
L1) The 4 green LEDs
indicate the running speed.
L2) When the LED is red
(motor off) it indicates the
FILTER ALARM. When the
LED is green (flashing) it
indicates that the TIMER has been activated with the key
E.
FILTER ALARM:
After 30h of operation, the LED L2 turns RED. It indicates
that the grease filters need to be cleaned.
After 120h of operation, the LED L2 turns RED and
flashes; It indicates that the grease filters need to be
cleaned and the charcoal filters replaced.
After cleaning the grease filters (and/or replacing the
charcoal filters), restart the hour counter (RESET) by
pressing the key E during display of the filter alarm.
MAINTENANCE
! Before cleaning or maintenance cut the power.
Cleaning the hood
WHEN TO CLEAN IT: clean it at least every 2 months to
prevent the risk of fire.
EXTERNAL CLEANING: use a cloth moistened in
lukewarm water and neutral detergent (for painted
hoods); use specific products for steel, copper or brass
hoods.
INTERNAL CLEANING: use a cloth (or brush) soaked in
denatured ethyl alcohol.
WHAT NOT TO DO: do not use abrasive or corrosive
products (e.g. metal sponges, brushes, too hard brushes,
very aggressive detergents, etc.)
L2
E R
L1
D OFF/+
C OFF/-
B ON
A OFF