Briteq BT700S Manual De Instrucciones página 9

ENGLISH
 BY EASY CONTROLLER:
When used in Master/slave mode we strongly advice you to use the CA-8 "Easy
controller" Just connect this small controller to the 1/4" jack of the master unit, and
you will be able to control the following
FUNCTIONS:
Stand by Blackout the unit
Strobe X/Y moving show pattern
1. Sync. strobe selection
2. Two-light strobe ( Show 1 ~ Show 4 )
Function
Sound 1 Sound 2
Mode
(LED off ) (LED slow blinking)
Important! Don't forget to select "On" for the "Lamp On/Power On" function in the main menu,
otherwise you will only see the movements with the lamp off ! Read more about this option in the
"Main Menu" paragraph.
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
 Clean the external optics at least once every 30 days.
 Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
BRITEQ 13/72
®
OPERATION MANUAL
Gobo/Color selection X/Y moving setting
1.Hold on for gobo 1.Pan position
selection 2.Tilt position
2.Press for color change 3.Dimmer
First set Master unit, then set
Slave units' position
Slow/Sound 3 Position/ Latch
(LED on) (LED fast blinking)
BT700S
ENGLISH
SPECIFICATIONS
Power Supply:
Sound Control:
Pan/Tilt:
Beam angle:
DMX connections:
Lamp:
Size:
Weight:
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.briteq-lighting.com
BRITEQ 14/72
®
OPERATION MANUAL
AC 230V, 50/60Hz
Internal microphone
540° / 270° with automatic correction
15°
3pin XLR male / female
HTI700W D4-75
674 x 471 x 406mm
32,6 kg
BT700S