Grip Assembly; Selecting The Cutting Means And Specific Guard; Fitting The Guard On The Cutting Means - Stiga BC 636 Manual De Instrucciones

4.2 GRIP ASSEMBLY

4.2.1 Assembly of the front hand grip
1. Position the cap (Fig. 3.A) by inserting
the pin (Fig. 3.A.1) into one of the holes
available on the transmission tube.
2. Fit the front grip complete with leg
guard barrier (Fig. 3.B) using the screws
(Fig. 3.C), taking care to keep the two anti-
vibration half-shells in place (Fig.3.D).
3. Fully tighten the screws (Fig. 3.C).
4.2.2 Fitting the handle bar- Type I
1. Unscrew the central knob (Fig. 4.A)
and remove the cap (Fig. 4.B).
2. Insert the handle bar (Fig. 4.C), making
sure that the controls are on the right.
3. Arrange the handle bar in the most
comfortable working position and
lock it using the cap (Fig. 4.B)
and the knob (Fig. 4.A).
4. Hook up the control sheath (Fig. 4.D) to
the appropriate cable clamp (Fig. 4.E).
NOTE Loosen the knob (Fig. 4.A) in
order to rotate the handle bar and reduce its
overall dimensions for storage purposes.
4.2.3 Fitting the handle bar - Type II
1. Insert the handle (Fig. 5.A) into its seat in
the transmission tube (Fig. 5.B), making
sure that the controls are on the right.
2. Tighten and lock the knob (Fig. 5
C) on the handle bar (Fig. 5 A).
4.3 SELECTING THE CUTTING
MEANS AND SPECIFIC GUARD
Every cutting means must
be fitted with a specific guard, as
indicated by the following directions
in the Technical Data table.
Choose the most suitable cutting means for the
job to be done, according to these general in-
structions:
• the cutting line head can eliminate tall
grass and non-woody vegetation near
fences, walls, foundations, pavements,
around trees, etc. or to completely clean
a particular area of the garden;
• the 3-point, 4-point and 8-point blades
are suitable for cutting brushwood and
small shrubs up to 2 cm in diameter;
• the saw blade (if allowed) is used to
cut wooden parts and fell small trees;
IMPORTANT Whenever you have to change
the cutting means, disassemble all its elements.
4.4 FITTING THE GUARD ON
THE CUTTING MEANS
Wear protective gloves.
4.4.1 Fitting the cutting means guard
(wire holder head, 3-point,
4-point and 8-point blade)
1. Unscrew the screws (Fig. 6.A).
2. Position the guard (Fig. 6.C) in line with
the holes on the transmission (Fig. 6.B).
3. Secure the guard (Fig. 6.A) fully
tightening the screws (Fig. 6.C).
NOTE The cutting means guard
(Fig. 1.E) has the following symbol:
It indicates the rotation direction
of the cutting means.
EN - 7