Control Panel - Polar CK640 Manual De Instrucciones

CK640 Blast Chiller / Freezer: Quick Start Guide

Control panel

Timed
Chilling LED
Set-Temperature
Chilling LED
Storage LED
Timed Positive Blast Chilling And Storage Cycle
To Set and Start Cycle:
• Make sure unit is in "standby" mode. The temperature of unit will flash in standby mode. If still
in cycle mode, please press the set button
• Once in "Standby" mode, press
left hand side of the controller is flashing.
• Press the set button
• To adjust the time, press and hold
• Press the set button
the time will start flashing once set button is pressed. Timer light will then remain on.
Please be aware, if previous cycle was a negative, a positive cycle will not run until unit
is back up to temperature.
Timed Negative Chilling And Storage Cycle
To Set and Start Cycle:
• Make sure unit is in "standby" mode. The temperature of unit will flash in standby mode. If still
in cycle mode, please press the set button
• Once in "Standby" mode, press
the left hand side of the controller is flashing.
• Press the set button
• To adjust the time, press and hold
• Press the set button
the time will start flashing once set button is pressed. Timer light will then remain on.
CK640_ML_A5_v4_20200728.indb 2 CK640_ML_A5_v4_20200728.indb 2
Alarm LED Minute LED
for 2 seconds to clear.
once to select "PoS" and ensure the
to show the pre-set time. (r1 parameter)
to reduce or
to start the cycle. The cycle will take 2 minutes to start. Red dot on
for 2 seconds to clear.
twice to select "nEG" and ensure the
to show the pre-set time. (r2 parameter)
to reduce or
to start the cycle. The cycle will take 2 minutes to start. Red dot on
Degree
Celsius LED
Degree
Fahrenheit LED
(timer) LED on the
to increase.
(timer) LED on
to increase.
2020/7/28 17:38 2020/7/28 17:38