Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Troubles
Troubles
When a trouble condition is detected, the Trouble (
beep every 10 seconds. Press the (
Trouble (
) or System indicator will flash. The corresponding trouble will light up.
Troubles
Low Battery
Service
Bell Circuit
Required (Press
for more
General System Trouble
details)
General System Tamper
If the building and/or neighborhood has lost electrical power, the system will
AC Loss
continue to operate on battery for several hours.
Phone Trouble
The system has detected that the telephone line is disconnected.
Communication
The system attempted to communicate with the monitoring station, but failed.
Failure
This may be due to Telephone Line Fault.
The system is experiencing difficulties with one or more sensors on the system.
Zone Fault
Press to display the zone.
The system has detected a tamper condition with one or more sensors on the sys-
Zone Tamper
tem. Press to display the zone.
The system has detected a low battery condition with one or more mod-
Wireless Low
ules/sensors on the system. Press to display the zone, keypad, wireless key(s) and
Battery
RF Delinquency low battery conditions. Press again to see zone troubles.
If complete power was lost (AC and Battery), the time and date will need to be
Loss of Clock
reprogrammed.
Additional Functions
Photos
You can create a slideshow of photos to View on the keypad. Photos are added using an SD card (32x24x2.1 mm.
Not supplied). See online user manual for details.
Quick Exit
If the system is armed and you need to exit, use the quick exit function to avoid disarming and rearming the sys-
tem. To activate this function, tap the Quick Exit icon. You have 2 minutes to leave the premises through your
exit door. When the door is closed again the remaining exit time is canceled.
Time & Date Programming
Tap on Options. Select User Functions [Master Code] and then select Time & Date. Tap on the section you would
like to change and use the up/down arrows to change time/date. Once done, press Save.
) or System indicator will turn on, and the keypad will
) key to silence the beeps. Press (
Comments
General System Supervision
RF Jam Detected
Panel Low Battery
Panel AC Loss
- 6 -
) to view the trouble condition. The
Action
Call for
service
Call for
service
Call for
service
Call for
service
Call for
service
Call for
service
Call for
service
Reprogram
Time &
Date
Publicidad
Tabla de contenido
