Toto YG20012R Manual De Instrucciones página 6

3. Attach the provided cap nut to the wall mount screw.
4. Use the 10mm socket wrench and tighten the screws.
5. Remove the cap nut.
6. Make sure there is a recess of 8-9mm (5/16"-3/8"). If not, use the Phillips screw
driver and tighten or loosen until there is a recess of 8-9mm (5/16"-3/8").
<Side View>
7. Mount the grab bar onto the screws and secure with flange nut using the
10mm wrench. For easy installation, first put the 2 nuts on the bottom 2
screws for easy installation.
INSTALLATION PROCEDURE
Stud,
Back Support
Wall Mount
Screw
5/16"~3/8"
[8~9mm]
Finished Wall
6
<Side View>
Stud,
Back Support
Wall Mount
Screw
5/16"~3/8"
[8~9mm]
Finished Wall