Ethernet Port Led Setting; Network Input Circuit Power Supply Setting; Remote Control Operation Setting - Esoteric N-01XD Manual Del Usuario

ETHERNET port LED setting

LanLED>***
Use to set the ETHERNET port LED. When set to OFF, the ETHERNET
port LED will not light, reducing the impact on audio quality.
o By default, the setting is OFF.
o Even when set to OFF, the LED will blink immediately after a LAN
cable is connected and while the unit is initializing after being
turned on (while "WAIT..." displayed).
OFF
The ETHERNET port LED stays unlit.
ON
Lighting and blinking of the ETHERNET port LED are enabled.
Network input circuit power supply
setting
NETin>***
Use to turn the network input circuit power supply on and off.
o By default, the setting is ON.
ON
This turns the network input circuit power supply on and plays
audio files from the network.
OFF
This turns the network input circuit power supply off, stopping
operation of the network input circuit.
NET will not be shown as an input source option (page 12).

Remote control operation setting

REMOTE>***
Use this to set signal reception from ESOTERIC remote controls included
with the P-05X and other products.
By default, the setting is OFF.
o Regardless of this setting, remote control DIMMER buttons will
function.
o Set this to OFF when you are using an ESOTERIC amplifier. If set to
ON, the amplifier will be operated at the same time.
OFF
This disables control of this product using the buttons on the remote
control.
ON
This enables control of this product using the buttons for amplifier
control on remote controls.
The following table shows the correspondence between remote
control and unit buttons.
Remote control N-01XD
SETUP button MENU button
INPUT button INPUT button
VOLUME (+/−) buttons Setting adjustment (l/;) buttons
19