Operations; Basic Operations; Adjusting The Volume; Switching The Display - Clarion CMD4 Manual De Instrucciones

6. OPERATIONS

Basic Operations

CAUTION
Lower the volume level before powering the
source unit off. The source unit stores the
last volume setting. If the source unit is
powered off with the volume up, when the
source unit is powered back on, the sudden
loud volume may harm your hearing and/or
damage the source unit.
WARNING
When the front panel is open, no sound is
produced, and source unit controls and
remote control unit operations are disabled.
Always shut the front panel after changing
the CD.
EXPOSING THE UNIT TO WATER WITH THE
FRONT PANEL OPEN WILL CAUSE
DAMAGE OR UNIT MALFUNCTION!
Turning on/off the power
1. Press the [POWER] button.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold the [POWER] button for 1
second or longer to turn off the power for the
unit.
Note:
• System check
During the initial power up of this unit, it will go
through a system check procedure. This
procedure verifies any devices connected through
CeNET. Any additional CeNET devices plugged
into the unit after the initial power up will initiate
the system check procedure. The system check
starts automatically within the unit.
Selecting a mode
1. Press the [CD/CDC], [SAT], [AM/FM] or
[AUX] button to change the operation mode.
2. Each time you press the [POWER] button,
the operation mode changes in the following
order:
Radio mode SIRIUS mode
CD changer mode
Radio mode...
∗ External equipment not connected with
CeNET is not displayed.
Note:Be sure to read this chapter referring to the front diagrams of
chapter "3. CONTROLS" on page 5 (unfold).
CD mode
AUX mode

Adjusting the volume

Turning the [ROTARY] knob clockwise
increases the volume; turning it
counterclockwise decreases the volume.
∗ The volume level is from 0 (minimum) to 33
(maximum).

Switching the display

Press the [DISP] button to select the desired
display.
Each time you press the [DISP] button, the
display switches in the following order:
Main display
Sub display (SIRIUS mode only)
Clock display
Main display
∗ Once selected, the preferred display becomes
the display default. When a function
adjustment such as volume is made, the
screen will momentarily switch to that
function's display, then revert back to the
preferred display several seconds after the
adjustment.
11
CMD4