Adding Regenerant; Manual Regeneration - Kinetico MACH Serie Manual Del Propietário

3. When depressurized, remove the filter sump
(when viewed from above) with two hands.
4. Remove the new cartridge and all contents from the protective bag,
and slide the bag over the used cartridge.
5. Remove the used cartridge by turning it clockwise. Discard used cartridge
with the bag, or clean and store for reuse.
6. Inspect and clean the sump seal and adapter O-ring, if necessary. Using
the included packet of silicone, lubricate entire seal, O-ring and the
sealing surface in the filter head
7. Install the new cartridge into the cartridge adapter by turning it counter-
clockwise until it stops
8. Install the filter sump by turning it counter-clockwise until it stops.
IMPORTANT! Check alignment of arrows to assure proper assembly
9. Turn the handle on the pressure relief valve to the CLOSED position
10. Turn on the feed water by slowly turning the by-pass to the SERVICE
position*.
* Your by-pass valve may be different than the one illustrated.
** Pressure relief valve may be in a different location than illustrated. If necessary, contact your
Kinetico dealer for assistance.
Note: Filter styles vary, and yours may not be exactly as previously described.

Adding Regenerant

Make sure your salt storage tank never runs out of regenerant. Refill
regenerant anytime before water is visible in the brine drum or softener
cabinet (on cabinet models). Use Kinetico Water Softener Salt, avail-
able from most Kinetico dealers, or another quality brand. Some salts
contain foreign particles which can cause problems with your system
so be sure to use a quality grade of salt, processed especially for use in
water softeners. If you choose to use potassium chloride, contact your
local authorized Kinetico dealer to find out about the recommended
adjustments to your system. Your Kinetico dealer can also recommend
or perform a schedule of periodic maintenance. DO NOT USE ROCK
SALT, as it often contains significant levels of dirt or foreign matter.

Manual Regeneration

If your salt storage tank does run out of salt, you can manually regenerate
the unit after adding salt, or you can wait for it to go through regeneration
automatically.
.
4
.
5
(water softener salt or potassium chloride)
by turning it clockwise
3
.
6
.
2
1