Thermador POD301 Manual De Uso Y Cuidado página 25

To replace the halogen bulb on the oven sidewall:
10W
Halogen
Lamp
Fixing
Clip
Housing
Ceramic
Holder
1. Turn off circuit breaker.
2. Remove oven racks.
3. Slide the tip of a flat blade screw driver between the
Slide
screw
4. Support the glass lens cover with two fingers along
driver tip
here
5. Gently twist the flat blade screw driver to loosen the
6. Remove the glass lens cover and fixing clip.
7. Remove the bulb by grasping and sliding the bulb
Loosen
glass lens
8. Do not touch the glass of the new replacement bulb
cover and
remove
9. Press in to seat the bulb.
10. Slide the protective lens into the holder clip and
11. Turn on circuit breaker.
Lens
Holder
Clip
fixing clip and the lamp housing.
the bottom edge to prevent the cover from falling to
the bottom of the oven.
glass lens cover.
straight out until the two prongs have cleared the
ceramic holder.
with your fingers. It will cause the bulb to fail when it
first lights. Grasp the replacement bulb with a clean
paper towel or facial tissue with the prongs facing
down. Locate the two prongs in the ceramic holder,
gently poking until the two prongs locate in the
ceramic socket.
push the other end until the fixing clip snaps back
into the housing.
English 23