First Use From New - EYENIMAL Training Soft Manual De Instrucciones

First use from new


 Fitting the battery in the EYENIMAL Training Soft receiver collar
- Use a coin to remove the battery cover.
- Insert the battery (3-V Lithium CR2450) paying attention to follow polarity indicated on the housing.
- A beep sound (low pitch) is emitted, indicating the correct installation of the battery. If you do not hear
any beep after having inserted the battery, remove it immediately from its housing. Check the polarity
before trying again.
- Put the battery cover back in place and use a coin to close it.
Diagram 3
 Activate/deactivate the EYENIMAL Training Soft remote control
Remote control is supplied with battery fitted.
- Activate: as soon as the battery is in place, the remote control is ready for use.
- Deactivate: to deactivate the remote control you have to remove the battery from its housing.
To increase the battery life of the remote control, we recommend you to deactivate the unit if you are
not using it for a long period.
 Activate/deactivate the EYENIMAL Training Soft receiver collar
A magnet located in the EYENIMAL Training Soft remote control is used to switch the receiver collar On
or Off.
- Activate: move the remote control towards the collar so that the round mark on the remote control
comes into contact with the white mark on the receiver collar, hold for 1 second (ref. Diagram 4). The
indicator light on the collar will flash in green indicating that the receiver is On.
- Deactivate: move the remote control towards the collar so that the round mark on the remote control
comes into contact with the white mark on the collar, hold for 1 second (ref. Diagram 4). The indicator
light on the collar will flash from green to red and then off: the receiver is Off.
Gb - 17
WARNING
Make sure the polarity
is correct.
Make sure the seal is in correct
position inside the collar before
replacing the battery cover.