bca TRACKER S Manual De Instrucciones página 9

Operating Instructions
Isolating multiple victims: Complex multiple burials are rare in
recreational settings and usually can be treated as a series of single burials
performed in normal search mode. The only time multiple burials can
become truly complex is when it's not possible to turn off the first victim's
transceiver, when the victims are in close proximity (≤10 m) to each other,
or if there are three or more victims.
The following icons help to determine how many buried victims are within
range of the rescuer and whether they are in close proximity to each other:
More than Two victims both
one signal within six meters
within range. of the searcher.
Both victims flashing Both victims
at the same time: flashing
Not enough data alternatively:
for suppression. Signal
suppression.
If it's not possible to turn off a victim's transceiver, use Signal Suppression
to find the next closest victim. Press and immediately release the
Options button (6). "SS" will be shown in the display and the icons in the
multiple burial indicator will flash back and forth. Follow the distance and
direction to the next victim. Remember that the first victim's signal will be
suppressed for one minute, at which time the icons in the multiple burial
indicator will stop flashing. To go back to normal search mode before one
minute has elapsed, simply press the Options button.
It is important to note that Signal Suppression, marking, and other
forms of signal isolation are not 100 percent reliable, especially when
searching for older analog transceivers. This is due to the possibility
of overlapping signals, especially when more than two transmit signals
are within range. Due to their imprecise transmit signals, analog
transceivers can sometimes trigger multiple burial indications. For these
reasons, it's important to learn some of the backup techniques described
at www.backcountryaccess.com/tracker-resources.
16
More than More than two signals
two signals within range and at least
within range. two within six meters.
Three middle directional arrows
are flashing while in suppression:
Overlapping signals.
Keep moving in the direction
you've been traveling.
Using Big Picture Mode: Big Picture mode is a valuable feature that can
be used to gain an overview of the scenario and optimize the efficiency
of your search. It can be used at the beginning of a scenario to assign
rescuers to each displayed signal. It is also valuable in situations involving
more than two signals within range.
Remember, Tracker S suppresses only one signal at a time. When you
suppress a second signal, it will then show you the next closest signal–
even if that victim's signal was suppressed earlier. If victim #3 is closer
to victim #2 than victim #1 (scenario A, below), then suppressing victim
#2's signal will take you to victim #3 automatically. However, if victim #1 is
closer than victim #3, (scenario B), Tracker S will bring you back to victim
#1. If this is the case, use Big Picture mode to find the general direction to
the third signal. After moving closer to the third signal, release the Options
button and Tracker S will automatically isolate that third signal.
Figure K
Tracker S suppresses one signal at a time. When suppressing victim #2's
signal, if victim #3 is further away from victim #2 than #1 (scenario B), then
use Big Picture mode to move toward #3.
Scenario A
#1
#2
#3
Operating Instructions
Scenario B
#1
#2
#3
17