cecotec CONGA 5090 Manual De Instrucciones página 36

ENGLISH
Edge mode and then another cycle in and organized zig zag motion,
recognizing which areas it has cleaned and which ones it has not.
The robot will plan the cleaning route automatically as it is cleaning.
If during this mode the robot is controlled manually, the robot will
calculate the route again and could go through previously cleaned
areas. In order to ensure efficient cleaning, do not operate it manually
during auto mode cleaning.
Thanks to its TotalSurface 2.0 technology, if the battery is low during the cleaning cycle, the
robot will smartly return to the charging base automatically and, once it is fully charged, it will
resume the cleaning process from the same point, offering a high-efficiency cleaning. During
cleaning, the robot will stop briefly to evaluate the area and calculate the cleaning route (this
stop will vary depending on the house conditions).
Warning: The robot cleans in an organized way and per 4x4 m squared areas, therefore it
might leave the room where it is cleaning to finish off the delimited area. Do not worry, the
robot will clean all the accessible surface.
2. Edge mode
Press the button on the remote control for the robot to start
cleaning under this mode. It will automatically start cleaning along
all the surface's perimeters and then will return to the charging
base direct and automatically. If the robot has not started cleaning
from the charging base, it will return to the starting point.
Note: Press the POWER button to switch between the 3 modes
Turbo/Normal/Eco.
3. Back home mode
Press the button on the remote control in order to send the
robot to the charging base. This mode can be activated during any
other cleaning cycle and the robot will stop cleaning and return to
the charging base automatically.
The robot will take the shortest route back to the charging base
thanks to its map memorizing and its smart back-home function.
When a cleaning cycle has been completed or the robot's battery is low, thanks to its
TotalSurface 2.0 technology, the robot will also return to the charging base to avoid running
36