cecotec CONGA 5090 Manual De Instrucciones página 40

ENGLISH
• Create an account with your e-mail and password.
• Confirm again.
• Add your Conga robot.
• Connect to Wi-Fi.
WARNINGS:
• The Wi-Fi name and password cannot exceed 32 bits.
• If the network configuration fails to connect, follow the steps below:
- Press the start button for 5 seconds, the robot will enter sleeping mode and the
Wi-Fi light indicator will blink fast indicating connection error. Retry connecting the
robot again following the steps in the before section.
- If the connection fails again, check if:
THE FOLLOWING MODES CAN BE OPERATED FROM THE APP:
1. Auto mode: Select this mode for the robot to clean 4x4 m quadrants. Within this space,
it will carry out a first cleaning cycle in Edge mode and then in zigzag motion to complete the
surface. Once it has finished, it will return directly to the charging base.
It can be activated from the robot, the App or the remote control.
Note: The robot could leave the room to complete the cleaning cycle in some of the quadrants. This
will not affect the robot's operating, do not worry.
2. Edge mode: Select this mode for the robot to clean along walls and furniture.
It can be activated from the App or the remote control.
3. Spiral mode: When this mode is selected, the robot will start cleaning in a specific point,
and then will clean carrying out moves in spiral motion outwards.
It can only be activated from the App.
4. Scrubbing mode: When this mode is activated, the robot moves in a swaying motion,
simulating real scrubbing moves. It starts off cleaning in Edge mode, then in zigzag motion
and finally returns to the charging base taking the straightest way back home.
It can only be activated from the App.
5. Manual mode: To carry out manual cleaning, use the direction buttons on the remote
control or on the App to take the robot to the specific points where you want it to clean.
It can be activated from the App or the remote control.
6. Back home mode: Select this mode at any point of any cleaning cycle and during any of
the modes, the robot will automatically return to the charging base.
It can be activated from the robot, the remote control or the App.
7. Smart Area mode: Once the home's map has been saved, select this mode for the robot
40
a. The robot is too far away from the router.
b. The Wi-Fi password is incorrect.