Basic Safety Rules; Installation; Label Data; Electrical Connection - Fulgor Milano FBC 4005 TC X Manual Del Usuario

1.6 Basic Safety Rules

The user is responsible for operations
carried out on the appliance without
following the instructions provided in this
manual.
The following are the main safety rules to be
observed for the installation:
• disconnect the appliance from the power
supply before working on it;
• to disconnect the appliance do not pull
the power cable;
• do not touch the appliance with wet or
damp hands/feet or without suitable
protections (e.g. suitable gloves and
shoes);
• do not insert
utensils or objects between the grids and
into moving parts.

2. INSTALLATION

2.1 Label data

The appliance data are indicated on a label
on the side (Fig. 4).
Fig. 4
Product data label
Note: do not remove, alter, damage or modify the
data label.
screwdrivers, kitchen

2.2 Electrical connection

Before installing the appliance ensure that
the existing electrical systems comply with
the law and correspond to the data on the
appliance label to be installed in terms of
voltage [V], frequency [Hz] and input power
[W]. The appliance has a power cable with
a 16A Schuko plug.
Warning! Once the installation is complete the
plug must be accessible. If this is not possible,
the power supply system must be equipped with
a disconnector.
Warning! Do not wind up the power cable and
make sure it is does not hinder or endanger peo-
ple passing through the area.
Warning!
Make sure the power cable is not
crumpled, squashed or bent.
Warning! The power cable must not get wet ,
come into contact with sharp or hot objects, or be
exposed to corrosive substances.
Warning! Avoid contact between the power ca-
ble and children or animals.

2.3 Positioning

Do not install in places with poor ventilation
and high temperatures, or locations in direct
sunlight or subject to weathering. Avoid
proximity to heat sources.
Warning! Make sure, once the installation is
complete, there are no obstacles to the door ope-
ning.
Warning! Do not use extensions to the power ca-
ble in order to avoid overheating problems..
Note: for the proper operation of the appliance an
air flue of at least 250 cm2 is required (Fig. 5) on
the rear of the appliance
Warning! Once the positioning is complete, se-
cure the appliance with suitable screws.
5
GB