Technical Characteristics; Diagnostics Led - tau K580M Guía Para La Instalación

MICROPROCESSOR-CONTROLLED LOGIC

INPUT STATUS LED'S

LINE INPUT FUSE

BUILT-IN FLASHING LIGHT CIRCUIT

433.92 MHz 2 CHANNEL BUILT-IN RADIO RECEIVER (CH)

OPERATING TIME FIXED AT 120 sec.

AUTOMATIC DETECTION OF THE FEEDING FREQUENCY (50 or 60 Hz)

MOTOR TORQUE CONTROL AND OBSTACLE DETECTION BY MEANS OF ENCODER

ADJUSTABLE DECELERATION

ATTENTION:
- do not use single cables (with one single wire), ex. telephone cables, in order to avoid
breakdowns of the line and false contacts;
- do not re-use old pre-existing cables.
When you have completed the connection:
 All the green LEDs must be on (each of them corresponds to a Normally Closed input). The
go off only when the controls to which they are associated are operated.
 The red opening command LEDs must all be unlit (each corresponding to a Normally Open
input) and illuminate only when the commands they are associated with are given; red LED
DL8 must be illuminated steadily.
Power input to board
Nominal power
Fast acting fuse for protection of input power supply 230 Vac (F1 - 5x20)
Input voltage of motor circuits
Input voltage of auxiliary circuits
Fast acting fuse for protection of auxiliary circuits 24 V dc (F2 - 5x20)
Working temperature
Box protected to
DL1
(PHOTO)
DL2
(SENSITIVE EDGE)
DL3
(CLOSE LIMIT SWITCH)
DL4
(OPEN LIMIT SWITCH)
DL5
(STOP)
DL6
(PEDESTRIAN)
DL7
(OPEN/CLOSE)
DL8
(RADIO CONTROLS)
12
CONTROL PANEL FOR ONE 230 Vac MOTOR
PHOTOCELL green LED signal
SENSITIVE EDGE green LED signal
CLOSE LIMIT SWITCH green LED signal
OPEN LIMIT SWITCH green LED signal
STOP button green LED signal
PEDESTRIAN button red LED signal
OPEN/CLOSE button red LED signal
RADIO CONTROLS programming red led
K580M

TECHNICAL CHARACTERISTICS

DIAGNOSTICS LED

English
TESTING
230 Vac - 50 Hz
400 W
F 3,15 A
230 Vac
24 Vac
F 500 mA
-20°C ÷ +70°C
IP 44