Periodic Review Of Ppe - Deltaplus AM020 Manual De Instrucciones

The shelf life is not a substitute for periodic verification (minimum annually) which will assess the condition of the
product.
TO FIND YOUR LOCAL ANNUAL REVIEW CENTRE, VISIT WWW.DELTAPLUS.EU.
No modification or addition or repair of the PPE may be made without prior written consent from the
manufacturer nor without using their procedures.
Do not use beyond the area of use defined in the instructions for use.
The manufacturer cannot be held liable for any direct or indirect accident after a modification or use other than
that provided in this manual.
Do not use this equipment beyond its limits.
To ensure its working condition and therefore the safety of the user, the product should be checked
systematically:
1 / visually inspect the following points:
-State of the strap or rope: no fraying, no boot cut, no visible damage at seams, no burning and no unusual
narrowing
- Condition of the metal parts: no wear, no deformation, no corrosion or oxidation
- General condition: look for any possible damage due to ultraviolet radiation and other climatic conditions
- That the fall indicator is not triggered
- Correct operation and locking of connectors
- That the shock absorber is not triggered (start of tear or tearing of the thermoplastic film and strap)
Specific conditions such as humidity, snow, ice, mud, dirt, paint, oil, glue, corrosion, wear of the strap or rope, etc..
can significantly reduce the operation of the fall arrest device.
2 / in the following cases:
- Before and during use
- if in doubt
- In the case of contact with chemicals, solvents or fuels that could affect operation
- If it has been subjected to stress during a previous fall
- At least every twelve months by the manufacturer or a competent organization, mandated by them.

PERIODIC REVIEW of PPE:

An examination should be performed at least every twelve months by the manufacturer or a competent
organization, mandated by them. This very important check is related to the maintenance and efficacy of the PPE
and hence the user's safety. A written document authorising reuse should be obtained during this audit in order to
reuse the PPE. This document will clarify that the user's safety is linked to maintaining the efficiency and
resistance of the equipment.
Replace the PPE if necessary.
In accordance with European regulations, the identification form must be completed prior to the first use of the
product and then updated and kept with the product as well as the manual by the user. The legibility of the
product labelling should be checked periodically.
WARNING:
The user's safety depends on the continuing efficacy of the PPE, its strength and the proper understanding of the
instructions in this manual.
WARNING: Any static or dynamic overload may damage the PPE.
WARNING: The weight of the user, including his clothing and equipment must not exceed the maximum weight
indicated on the fall arrest
It is dangerous to create your own fall arrest system as each safety function may interfere with another safety
function.
WARNING:
No modification or addition or repair of the PPE may be made without prior written consent from the
manufacturer without using their procedures.
Do not use beyond the scope of use defined in the usage instructions, nor beyond its limits.
The manufacturer cannot be held liable for any direct or indirect accident after a modification or use other than
that provided in this manual.
This equipment should be used in work environments with minimum temperatures of -40°C / maximum of +50°C.
9
UPDATE : 24/02/2014