Hkoenig V5i Manual De Instrucciones página 7

HOW TO USE YOUR STEAM STATION
Prepare the appliance for use
1. Check if the rating indicated in the rating plate
corresponding to the main voltage in your home.
2. Press handle button to lay handle down.
3. Remove the protective foil or sticker or card from the
soleplate. (Fig. 1)
4. Fully unwind and straighten the power cord and the supply
hose.
5. Place the appliance on a stable, level and horizontal surface
such as ironing board
6. Place the iron onto the iron rest plate horizontally at the
base unit.
Fill water tank
1. Press the water tank Iock upwards and slide the
detachable water tank outwards from the base. (Fig.2)
2. Take the filter upwards out from the water fill hole.
(You can take the filter out of the opening for filling water
into water tank, or fill water into water tank directly with
the filter existing in the opening). (Fig.3)
3. Fill the water tank up to or below the "MAX" fill line
with clean tap water. (Fig.4)
4. Replace filter back into water tank. When move,
please hold the water tank by two hands. (Fig.5)
5. Replace the water tank into the base unit again. lt
will be locked in place with the base unit until a
"click" sound is provided. (Fig.6)
6. Always pour out the remaining water after use. (Fig.
7)
Note: When the water level reaches a low level or empty,
pump will provide sound to indicate refilling. lt must stop
to use the appliance im mediately and refill water tank as
the methods mentioned above.
Steam function setting
After power on, set temperature contrai dial to steam
iraning position. Heating the indicator light on an iron unit
lights up to indicate the unit being heated up. When
desired temperature has been reached, heating indicator
light turns off, it is ready for using. During use, heating
indicator light will cycle from ON to OFF and then OFF to
ON, it indicates that the iran is automatically heat
preservation. Press steam button to start steam iraning.
When you adjust the temperature contrai dial, steam rate
will be adjusted accordingly. MAX steam will be obtained
when set at MAX position, it will be smaller gradually when
turn to "WOOL" position.
Note: When temperature contrai dial is located at
SYNTHETIC ", it is praposed not to activate steam iraning
since temperature is too low to praduce steam, it only suits for dry ironing,