Mechanical Center; Diopter And Parallax Adjustment; Zeroing The Rifle Scope; Sighting In The Rifle Scope - KAHLES K4i Manual De Instrucciones

• All repairs must be performed by KAHLES
• The rifle scope must be mounted by professional gunsmith
• Attention – the screws of mounts shall in no case be
tightened stronger than max. 240 Ncm
• Always check carefully and be certain that your firearm is
unloaded before undertaking any work upon it

4. MECHANICAL CENTER

The reticle has been factory-set to optical center. If you need
to reset, follow these steps:
1. Turn the elevation or windage adjustment until it stops (do
not force).
2. Now turn the adjustment in the opposite direction while
counting the total number of clicks until it stops.
3. Half of this total number of clicks is the optical center.
4. Repeat this procedure for the second adjustment turret.
Pay attention, never use any strong force when you do any adjust-
ments on the turrets.

5. DIOPTER AND PARALLAX ADJUSTMENT

• Turn the diopter compensation ring (1) until you get a
sharp reticle image
• Turn the parallax adjustment wheel (3) until you achieve a
sharp image and the reticle does not move on the target
due to head placement.
• Magnification ring (2) turn to increase or decrease
magnification

6. SIGHTING IN THE RIFLE SCOPE

After the rifle scope has been properly mounted and bore
sighted by a professional gunsmith you will need to sight in
your rifle and rifle scope. Attention – the screws of mounts
shall in no case be tightened stronger than max. 240 Ncm!
Never miss THE MOMENT!
K AHLES –
Symbol picture
2
3
E
1
19