Joie juva Manual De Instrucciones página 10

i. Installing without
Base
see images -
21 24
After fitting the harness to your
child and determining which rear
vehicle seat location is best, you
are ready to install your infant
child restraint.
1. Place the infant child restraint
onto the vehicle seat where
you wish to put it, pull the
vehicle safety belt and slide the
lap belt into the two side
guides of the infant child
restraint, and lock it into the
buckle.
21
!
The child restraint can
not be used if the vehicle
safety belt buckle (female
buckle end) is too long to
anchor the child restraint
securely. -1
21
2. Slide diagonal belt into the rear
guide.
22
15
21 !
!
1
22
!
3. Pull the belt to fasten the infant
child restraint tightly and
securely.
23
!
Tension the vehicle safety
belt as much as possible,
check that it is not loose or
twisted.
!
The vehicle safety belt shall
not cause pressure on any
part of the child.
Correctly assembled vehicle
safety belt is shown as
24
!
Lap belt must pass through
the two side guides,
as -1
24
!
The vehicle buckle is locked
correctly, as -2
24
!
Diagonal belt must pass
through the rear guide,
as -3
24
23
24
1
3
2
16